EM3270 Manual

Basic and Advanced Sessions With EM3270
Tandem EM3270 Manual—110332 3-15
Kanji Emulator Session
where pathfile contains the following commands. You can include a comment with any
PATHCOM command by preceding the comment with a left square bracket ([).
PATHCOM commands irrelevant to this example are omitted:
SET Pathway ... [Configure Pathway.
.
.
.
START Pathway COLD
SET TCP ... [Configure the TCP.
SET TCP TERMBUF 4000 [Maximum buffer size for EM3270.
.
.
.
ADD TCP TCP1
SET TERM FILE $EM.#AM.T1 [Configure CRT1.
SET TERM DISPLAY-PAGES 7
SET TERM INITIAL EXAMPLE
SET TERM TCP TCP1
ADD TERM CRT1
SET PROGRAM ... [Configure SCOBOL program.
.
.
.
ADD PROGRAM EXPROG
SET SERVER ... [Configure the server.
.
.
.
ADD SERVER EXSERVER
START TCP TCP1 [Start the TCP.
START TERM *
Kanji Emulator Session
This subsection describes an EM3270 emulator session with Kanji terminals accessing
Kanji hosts. It describes a central operator control configuration that brings up the
emulator by invoking EMCOM in noninteractive mode.
The example of the EM3270 emulator environment is shown in Figure 3-4. In this
figure, all control processes, such as SCF, SPOOLCOM, PATHCOM, and PATHMON,
have been omitted for clarity. All three terminals are configured to the IBM and Fujitsu
hosts. In the example, the sessions listed in Table 3-2 are applicable.