EM3270 Manual

Basic and Advanced Sessions With EM3270
Tandem EM3270 Manual—110332 3-19
Starting the Tandem Application for Kanji
SET ALIAS3 “FUJITSU HOST (AIM1)”
ADD $ATP.#T1 --Add PC6530-J terminal.
SET HOST $SNK.#LU2
SET HOST1 $SNK.#LU2
SET HOST2 $FNK.#LU2
SET HOST3 $FNK.#LU2
ADD $SNKP.#T3 --Add IBM 3270 Kanji terminal.
SET HOST $SNK.#LU3
SET HOST1 $SNK.#LU3
SET HOST2 $FNK.#LU3
SET HOST3 $FNK.#LU3
SET JEF2EXT ON --Select Fujitsu 6680 terminal.
ADD $FNKP.#T3 --Add Fujitsu Kanji terminal.
RESET DEVICE
SET HOST $SNK.#LU4 --Configure IBM host printer LU.
SET DEVICETYPE PRINTER --Assign to Fujitsu printer.
SET HOSTDBCS IBMMIXED
SET HOSTCSET KATAKANA
SET TIMEOUT 60
ADD $S.#P2
SET HOST $SNK.#LU5 --Configure IBM host printer LU.
ADD $S.#P3 --Assign to Tandem printer.
SET HOSTDBCS JEFKANJI
SET HOST $FNK.#LU4 --Configure Fujitsu host printer LU.
ADD $S.#P1 --Assign to IBM printer.
SET HOST $FNK.#LU5 --Configure Fujitsu host printer LU.
ADD $S.#P3X --Assign to Tandem printer.
At this point, the EM3270 emulator is operational and the status message “EM3270
KANJI EXAMPLE” displays on line 25 of CRT1. This does not display on CRT2 and
CRT3.
Starting the Tandem Application for Kanji
The Tandem application (Pathway) for the dual-application session on CRT1, CRT2, and
CRT3 is started by the following commands:
PATHMON/NAME $PW,NOWAIT/
PATHCOM/IN pathfile/$PW
where pathfile contains (PATHCOM commands irrelevant to this example are omitted):
SET Pathway ... [Configure Pathway.
.
.
.
START Pathway COLD
SET TCP ... [Configure the TCP.
SET TCP TERMBUF 4000 [Maximum buffer size for EM3270.