EM3270 Manual

EM3270 Emulator Command Set
Tandem EM3270 Manual—110332 4-5
ALTER Command
object-type object-name
identifies the object to be altered. It can be one of the following:
object-type object-name
DEVICE { device-name | task-number }
PROCESS process-name
device-name
specifies the device name, which must be a fully qualified network terminal or
printer file name.
task-number
specifies the task number of the terminal to be reconfigured. It is the task
number from the STATUS command display.
process-name
specifies the name of the EM3270 emulator process whose backup processor
you wish to alter or set up. You must specify a value for process-name.
parameter-spec
indicates what is to be altered.
The parameter-spec for a DEVICE object is the following:
parameter [,parameter] ...
parameter
specifies a SET DEVICE parameter (see the SET DEVICE command in this
section). The parameter for a PROCESS object can be one of the following:
BACKUP cpu-number
LOGOPENS { ON | OFF }
MODEMERR { ON | OFF }
AUTORESTART { ON | OFF }
SHIELD { ON | OFF }
NOTIFY { ON | OFF }
READTRSIZE value
TERMBUFSIZE value
RUGATHER { ON | OFF }
ESC3270 keycode