EM3270 Manual

EM3270 Emulator Command Set
Tandem EM3270 Manual—110332 4-29
SHOW Command
Examples
Examples of the SET DEVICE command follow:
ASSUME DEVICE
SET HOST \TNSII.$SNX1.#TERM8
SET LINK OFF
SET SNALOGON APPLID "IMS"
SET SNALOGON LOGMODE "LOGTAB1"
SET PAGES 7
SET CPRINTER \NSNODE.$S.#HYTYPE
SET EOFTEXT "--EOF"
SET TIMEOUT 20
SET LIKE $TERMIO
SET HUNT ON
Examples of the SET PROCESS command follow:
ASSUME PROCESS
SET CPUS 1:2
SET PROCID $EM1
SET PRI 170
SET LOG1 $0
SET LOG2 $PTR3
SET PROGRAM $USER.SUBVOL.EM3270
SET NUMLOCK ON
SET SECURITY "-"
SET ADVISORY "IBM MODE"
SET LIKE $EM2
Messages
The following error messages are common to all SET subcommands. Messages that are
specific to individual subcommands are listed after each subcommand description.
Examples of SET command usage follow the last subcommand description.
ERROR *1015* MISSING SET PARAMETER
ERROR *1071* INVALID OBJECT TYPE
SHOW Command
The SHOW command causes EMCOM to display the current settings of one or all of the
SET DEVICE or SET PROCESS parameters. If you do not specify a value for
parameter, all of the SET parameters are displayed. This command applies to the
parameters used when accessing EMCOM or starting a process. The SHOW command
lists these parameters for EMCOM only. To check the parameter settings in a running
EM3270 process, use the INFO command.
SHOW [ object-type ] [ parameter-spec ]