EM3270 Manual

START Command
4-30 110332—Tandem EM3270 Manual
EM3270 Emulator Command Set
object-type
indicates whether settings for SET DEVICE parameters or SET PROCESS
parameters are to be displayed. If no object type is specified, the default object type
is used. object-type can be one of the following:
DEVICE
PROCESS
parameter-spec
specifies which SET parameters are to be displayed. It can be the following:
parameter [, parameter ] ...
parameter
specifies a SET parameter for which the current setting is to be displayed. If
parameter is not specified, the current settings for all SET parameters for the
object type are displayed.
Messages
1015, 1069, 1070, and 1071.
START Command
The START command starts either a new EM3270 emulator process or one or more
terminals. If you specify a START PROCESS command, EMCOM creates a new
EM3270 emulator process using the runtime parameters currently set (see the SET and
SHOW commands). If you specify a START DEVICE command and either file-name or
task-number, the designated terminal is activated. If you specify *, all configured
terminals are activated by the currently open EM3270 emulator process.
object-type object-name
identifies the object to be started. It can be one of the following:
object-type object-name
DEVICE { file-name | task-number | * }
PROCESS [ process-name ]
file-name
specifies a fully qualified network terminal file name.
task-number
specifies the task number of the terminal to be started. It is the task number
from the STATUS command display.
START [ object-type ] object-name