EMS FastStart Manual

EMS FastStart Manual–133701

5-1

Running EMS FastStart

This section describes how to run EMS FastStart. It outlines the procedure for first

Setting Up the EMS FastStart Environment and then Running EMSFS with the

GENERATE command.

The message you receive after a successful completion of the setup as well as two

possible error messages if the setup cannot be completed are shown and explained.

Then, Stopping EMSFS and Detaching the Segment File

after the run is completed is

described. Next, a sample run is shown including the commands you must enter and the

text you see on your terminal.

At the end of this section, the User Subvolume Files

and EMSFS Components are listed

and described. There is also information about the warning, advisory, and error

messages you may receive when you run EMS FastStart, (listed and described in detail

in Appendix A, EMS FastStart Messages).

Figure 5-1

illustrates the generation process: parameter validation, cleaning the

subvolume, source file generation, automatic compilation, and file creation. The figure

also shows the resulting EMS FastStart components: copy libraries, the EGEN routine,

the test program, the DDL source code, and the filter.

Figure 5-1. EMS FastStart Generation Process

TACL> generate SATMACF

Parameter Validation

Cleaning Subvolume

Source File Generation

Automatic Compilation

File Creation

Copy Lib. EGEN Test FilterDDL

004