EMS FastStart Manual

Running EMS FastStart

EMS FastStart Manual–133701

5-2

Setting Up the EMS FastStart Environment

Before using EMS FastStart, you must attach the EMSFSC20 segment file to your

TACL.

A TACL macro is provided to simplify this operation. Enter the following commands

exactly as specified to be sure that your working environment is properly initialized.

At the TACL prompt enter:

1> VOLUME EMS-FastStart-working-subvolume

This command sets your default subvolume to the EMS FastStart development

subvolume (for example, VOLUME $DEV.ZEMSFS).

At the TACL prompt enter:

2> RUN EMSFS

This command invokes the EMSFS TACL macro which attaches the EMSFSC20

segment file to your TACL. This macro also checks that the version of EMSFS matches

the version of the segment file.

The following message appears on your terminal if the EMS FastStart setup was

successfully completed.

One of the following two error messages will appear on your terminal if the EMS

FastStart set up was unsuccessful.

Error Message 1

EMS FastStart - T9263C20 - (17MAR91)

** Comment 1 ** EMS FastStart set up completed.

Enter the GENERATE <acf-filename> command to start an EMS FastStart

session.

EMS FastStart - T9263C20 - (17MAR91)

** Error 1 ** EMS FastStart set up failed.

Probable Cause: The segment file version does not match the startup file

version.

Segment file version = <segment file version>

Startup file version = <startup file version>

Recommended Action: Reinstall EMS FastStart to ensure that the segment

file and the startup file have the same version.