EMS FastStart Manual

Running EMS FastStart

EMS FastStart Manual–133701

5-4

Running EMS FastStart–ATM Example

This section shows you how to generate a sample run of EMS FastStart using the default

ACF called SATMACF.

Following the command entries, a listing of what you will see on your screen is shown.

In order to clarify the process, the listing is divided into steps which are grouped as

follows:

Parameter Validation (Steps 1-2)

Cleaning the Subvolume (Step 3)

Source File Generation (Steps 4 - 8)

Automatic Compilation (Steps 9 - 13)

File Creation: ATM1TEST and ATM1INDX (Steps 14 - 16)

Note that the EMS FastStart run will stop if an error occurs. You will receive an error

message advising you of the probable cause and the recommended action (listed and

described in detail in Appendix A, EMS FastStart Messages

. Correct the error and run

the program again.

Here is a sample EMS FastStart run:

Enter the GENERATE acf-filename command to start an EMS FastStart session.

The EMS FastStart response following the RUN and GENERATE commands is shown

below as it will appear on your screen.

Parameter Validation (Steps 1-2)

Steps 1 and 2 show the validation of the ACF and CCF parameters.

STEP #1: Reading and validating the ACF: $DATA.ZEMSFS.SATMACF.

--------------------------------------------------------------------------

-- EMS FastStart - T9263C20 - (17MAR91)

-- File Type: ACF

-- File Version: B00

-- Creation Date: September 17, 1989 10:54:31

TACL> volume $data.zemsfs

TACL> run emsfs

EMS FastStart - T9263C20 - (17MAR91)

** Comment 1 ** EMS FastStart set up completed.

TACL> generate satmacf

EMS FastStart - T9263C20 - (17MAR91)

, Operating System C20, System name \MTL

October 15, 1989 22:24:28