EMS Manual

Distributor Event Messages
EMS Manual—426909-005
18-22
1005: ZEMS-EVT-BAD-FILTER
ZEMS-TKN-GENTIME, -LOGTIME, -CPU, -PROC-DESC, -PIN, -NODENUM,
and -USERID
are standard EMS tokens described in Section 14, EMS Definitions.
ZEMS-TKN-SUBJECT-MARK (shared)
is the standard EMS token that immediately precedes each subject token. This
event message has one subject token:
ZEMS-TKN-FILTERNAME (nonshared)
is the name of the filter given in the filter specification at compilation time. Here
it is the filter used by the distributor when it detected the filter error.
ZSPI-TKN-PROC-ERR (nonshared)
specifies a procedure associated with the event. Here EMS assigns one of these
values:
ZEMS-VAL-ZFILOPEN 22
ZEMS-VAL-ZFILPOSITION 23
ZEMS-VAL-ZFILREAD 24
The extensible structured token ZEMS-MAP-STATUS-DIST and the tokens
-RECORD-ADDRESS, -FILTER-ERROR, ZEMS-TKN-LOGNAME, -COLNAME-ENUM,
and -COLNAME are described in Token and Data Type Definitions on page 18-3.
Cause. The distributor detected a filter error while filtering event messages.
Effect. The distributor suspends event-message processing.
Recovery. Load a new filter or change the filter parameters. If you still have problems,
contact your HP representative.