EMS Manual

Distributor Event Messages
EMS Manual—426909-005
18-24
1006: ZEMS-EVT-COLL-PROTOCOL
ZEMS-TKN-SUBJECT-MARK (shared)
is the standard EMS token that immediately precedes each subject token. This
event message has one subject token:
ZEMS-TKN-COLNAME (nonshared)
is the name of a collector. Here it is the collector that responded to the
distributor with an invalid SPI response.
ZSPI-TKN-PROC-ERR (nonshared)
specifies a procedure associated with the event. Here EMS assigns the value of
ZSPI-VAL-SSGET to 2.
ZEMS-MAP-STATUS-DIST is an extensible structured token described in Token and
Data Type Definitions on page 18-3.
Cause. The distributor detected an invalid response to a command message issued to
a collector. The collector is malfunctioning or has aborted.
Effect. The distributor disconnects the failing collector but continues to run.
Recovery. Make sure you specified a valid EMS collector name. If you did specify a
valid name, contact your service provider. An application can direct the distributor to
reconnect the same collector after the collector is again operational.