EMS Manual

Distributor Event Messages
EMS Manual—426909-005
18-26
1007: ZEMS-EVT-BAD-EVENT
ZEMS-TKN-GENTIME, -LOGTIME, -CPU, -PROC-DESC, -PIN, -NODENUM,
and -USERID
are standard EMS tokens described in Section 14, EMS Definitions.
ZEMS-TKN-SUBJECT-MARK (shared)
is the standard EMS token that immediately precedes each subject token. This
event message has one subject token:
ZEMS-TKN-LOGNAME (nonshared)
is the file name of a log file. Here it is the log file in use when the distributor
read the bad event message.
ZSPI-TKN-PROC-ERR (nonshared)
specifies a procedure associated with the event. Here EMS assigns one of these
values:
ZEMS-VAL-FILTER-EVAL 20
ZSPI-VAL-SSGETTKN 3
For descriptions of the extensible structured token ZEMS-MAP-STATUS-DIST and the
tokens RECORD-ADDRESS, ZEMS-TOKEN-COLNAME, and -COLNAME-ENUM, see
Token and Data Type Definitions on page 18-3.
Cause. A distributor reads an event message from a log file and finds the message is
not a valid event message.
Effect. The distributor continues to process event messages, skipping the invalid
event message. After five invalid event messages are detected, the event message
(ZEMS-EVT-BAD-LOG) is generated.
Recovery. This event message is informative only. No corrective action is necessary.