EMS Manual

Collector Event Messages
EMS Manual—426909-005
20-62
539: ZEMS-EVT-BURST-END
ZEMS-TKN-BURST-EVTS-DELETED
are occurrences of the bursting event that were not logged during the event burst.
ZEMS-TKN-BURST-END-REASON
is the reason for the event burst end. A value of ZEMS-VAL-BDS-DISABLED
means that the burst ended because BDS was terminated by the operator. A value
of ZEMS-VAL-NO-EVENTS means that the burst ended because no further events
were detected during the last T2 time units.
Text Values
eventno
is from ZEMS-TKN-BURST-EVT-NUM.
ssid
is from ZEMS-TKN-BURST-SSID.
proc-desc
is from ZEMS-TKN-BURST-PROC-DESC.
count
is from ZEMS-TKN-BURST-EVTS-DELETED.
Cause. An event burst ended for one of these reasons:

The bursting event did not occur for the time interval T2 specified in the BDS
configuration (during which an event burst must occur at least once).

BDS was disabled while bursting events were being suppressed, in which case
an Event Burst Ended event is generated for every monitored event burst.
Effect. The next occurrence of the formerly bursting event is logged to disk.
Recovery. None. This is an informational message.
The timestamp stored in the BURST-TIME-START token matches the timestamp that is
stored in the corresponding burst start event.