EMS Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

691

692

693

694

695

696

697

698

699

700

Distributor Errors

EMS Manual—426909-005

21-22

1064: ZEMS-ERR-STARTUP-FAILED

ZSPI-TKN-PROC-ERR

can have the values:

ZEMS-VAL-NEWPROCESS

ZEMS-VAL-ZFILOPEN

ZEMS-VAL-ZFILWRITE

Cause. An attempt to launch a destination process was unsuccessful. Either a

process create failure, an open error, or an error occurred during the write of the

startup message.

Effect. Only the initial launching error is reported, not subsequent retry errors. If the

startup eventually succeeds, ZEMS-WRN-STARTUP-OK is issued.

Recovery. Determine from the event ZEMS-EVT-STARTUP-FAILED what value the

ZEMS-TKN-NEWPROCESS-ERROR has.

1065: ZEMS-ERR-WRITE-FAILED

Cause. A timeout occurred after an attempt was made to write an event to a

destination process. The error could be the result of unsuccessful retries, or the

recipient did not acknowledge the request by reading the $RECEIVE file. The cause

might be an abended destination process.

Effect. The error message is repeated every 24 hours, and a count of the failed write

operations is attached.

Recovery. Determine the nature of the problem and correct it. Monitor the event

messages.

ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST

ZSPI-TKN-PROC-ERR token-type ZSPI-TYP-ENUM

ZEMS-TKN-FAILFILENAME token-type ZSPI-TYP-FNAME

ZSPI-TKN-PROGRAMFILE token-type ZSPI-TYP-FNAME

ZSPI-TKN-ZFILERR token-type ZSPI-TYP-UINT

ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR

ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL