EMS Manual

EMS Manual—426909-005
22-1
22 Collector Errors
This section lists the error codes returned by the primary and alternate EMS collectors
in their three categories:
These categories are based on the type of SPI-compliant collector commands to which
the collectors send the errors in response.
For descriptions of all these collector commands, see Section 19, Collector Commands
and Responses.
There is some commonality among the error names listed for ZEMS- errors generated
by the extended SPI-compliant interface and ZEMS- errors generated over the basic
SPI interface. However, the error list tokens generated are different. Accordingly, the
ZEMS- errors are described twice, once for each SPI interface.
Following the code of each error or warning is a box with the name and type of tokens
that constitute the related error list. Following the box is a description of the error’s
cause, effect, and recovery actions that can be taken.
All collector command responses contain the command header and the ZSPI-TKN-
RETCODE token. They contain an error list if the ZSPI-TKN-RETCODE value is
nonzero.
Use the SSGET and SSGETTKN procedures to get the ZSPI-TKN-RETCODE or error-
list tokens. These procedures also provide special operations that enable you to
extract information from the command header. For information about SSGET and
SSGETTKN, see the SPI Programming Manual and the SPI Common Extensions
Manual.
Topic Page
ZCOM- Errors (Over Extended SPI Interface)
22-2
ZEMS- Errors (Over Extended SPI Interface) 22-10
ZEMS- Errors (Over Basic SPI Interface) 22-19