EMS Manual

Collector Errors
EMS Manual—426909-005
22-4
-3: ZCOM-ERR-CMD-INV-IN-SUMSTATE
ZSPI-TKN-ERROR.Z-ERROR (type enum)
contains the SPI error number (ZSPI-ERROR-error).
ZSPI-TKN-ERROR.PROC-ERROR (type int)
identifies the SPI procedure that encountered the error (ZSPI-VAL-proc).
ZSPI-TKN-ENDLIST (type ssctl)
marks the end of the nested file-system error list.
ZSPI-TKN-ENDLIST (type ssctl)
is the SPI token that ends a list—an error list in this section.
-3: ZCOM-ERR-CMD-INV-IN-SUMSTATE
Cause. The command cannot be applied to the object in its current summary state.
You either attempted to activate SUPPRESS ON or change a SUPPRESS parameter
when a burst filter was installed, or you attempted to change the S or L suppress
parameters or add a burst filter while BDS was enabled.
Effect. The desired action does not take effect.
Recovery. In the first case, remove the burst filter before using the SUPPRESS
parameter, or alter the burst filter then replace it. In the latter case, add a burst filter, or
disable BDS and change the S or L parameter.
-4: ZCOM-ERR-CMD-MISMATCH
Cause. A mismatch occurred between the command and object type. The command
does not support the specified object type.
Effect. The command is not executed.
Recovery. Check that the object type you specify is supported by the command you
use.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
ZCOM-TKN-OBJSTATE token-type ZSPI-TYP-ENUM
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL