EMS Manual

Standard Event Sample Files
EMS Manual—426909-005
C-10
Event External Specification Sample File
* CPU CPU no. of event sender
* EMPHASIS critical event?
* EVENTNUMBER event number
* GENTIME event generation time
* LOGTIME event log time
* NAME-MANAGER manager process name
* NODENUM system no. of event sender
* PIN PIN of event sender
* SUBJECT-MARK event subject marker
* SUPPRESS-DISPLAY display event?
* USERID user ID of event sender
<<Replace "*" with blank for tokens your subsystem does not
support. Do not delete any of these tokens from the table
here.>>
* ACTION-ID action id
* ACTION-NEEDED operator action needed?
* CHANGE-REASON object state change reason
<<Add your private enumerations here.>>
* FAILURE-CAUSE object unavailable cause
* INFO-CHANNEL-UNIT I/O channel unit info
* NAME-CODEFILE Guardian process codefile name
* NAME-PROCESS Guardian process descriptor
* NAME-DUMPFILE Guardian process dumpfile name
* PLATFORM-TYP T/16 cpu type
* REGISTERS-T16 T/16 P/E registers
* STATE-CURRENT current object state
<<Add your private enumerations here.>>
* STATE-PREVIOUS previous object state
<<Add your private enumerations here.>>
* SYMPTOM-STRING symptom string
* TRAP-CODE Guardian 90 trap code
* TXFAULT-TYPE type of transient fault
<<Add your private enumerations here.>>
* XSYSPID PID of Guardian process
* UTIL-CONFIG-HI configured resource level (high)
* UTIL-CONFIG-LOW configured resource level (low)
* UTIL-LEVEL-CURR current resource usage level
* UTIL-LEVEL-PREV previous reported usage level
* UTIL-TIME-PREV previous reported usage timestamp
<<
If you do not use tokens defined by other subsystems, state
"None" here. Do not delete this subsection.
If you use tokens defined by other subsystems, create a table
for each subsystem on a new page. List the tokens from that
subsystem that you use in the table. Follow the same table
format that is used in the "Standard EMS tokens" subsection
earlier. Use this outline for your subsection:
\new