ENABLE Reference Manual

APPLICATION EXECUTION
Establishing a PATHWAY System
-----------------------------------------------------------------
| |
| <pathcom-command-file-name> |
| |
| is the name of the PATHCOM command file created by |
| ENABLE. ENABLE creates this file if you supply a value |
| for the PATHCOMFILE attribute when you generate an |
| application. |
| |
| <program-name> |
| |
| is the name of the generated application. |
| |
| Within the PATHMON command, CPU 0 identifies the processor |
| in which the primary PATHMON process runs. The PATHCOM |
| command file produced by ENABLE identifies CPU 1 as the |
| processor in which the backup process runs. Your system |
| manager may want you to select different CPUs by editing |
| this command and the PATHCOM command file. |
| |
-----------------------------------------------------------------
Figure 6-1. Commands to Establish a PATHWAY System and
Execute an Application (Continued)
The commands listed in Figure 6-1 do the following:
PURGE <log-file>, <path-control-file> Purges the log file and
the path-control-file.
CREATE <log-file> Creates a log file.
ASSIGN PATHCTL, <path-control-file> Assigns PATHCTL (the
default
path-control-file) to
the file of your
choice.
PATHMON/NAME <pathmon-name>, Starts a PATHMON
NOWAIT, CPU 0, OUT <log-file>/ process and gives the
process a name. This
command also identifies
the primary CPU in
which the PATHMON
process is to run and
identifies the log file
used by the process.
PATHCOM/ IN <pathcom-command-file/ Configures the PATHWAY
<pathmon-name> system.
6-3