ENABLE Reference Manual

RUNNING ENABLE
ENABLE Commands--Usage Overview
S5043-012
Starting Value:
Current Value:
Override Value:
Default Value:
Sample Application Attributes Sample Box Attributes
TITLE TREE PATHCOMFILE RECORD DELETE DATAFILE
Null Null Null Null ON Null
%ADD APPL parts-in, TREE (01 parts-box)
ENABLE
PARTSENABPATH
(01 PARTS-BOX)
PARTS-IN
Figure 2-8. Default Value for an Application Attribute
ENABLE supplies the default value of an attribute at the same
time that it enters an override value for an attribute.
When ENABLE adds an application to the object table, it removes
any override or default values for application attributes.
ENABLE does not remove any current values of application
attributes. These values remain in the attribute table until you
supply a new current value with another SET APPL command, reset
the attribute to its starting value with a RESET command, or exit
from ENABLE.
Adding an Object
To add an object to the object table explicitly, you must use the
ADD command. Under certain conditions, ENABLE implicitly adds an
object to the object table for you. (Section 4 describes these
conditions.) In some cases, implicitly adding an object can lead
to unexpected results; to avoid this problem, explicitly add each
object with an ADD command.
2-21