Enscribe Programmer's Guide

What’s New in This Manual
Manual Information
Abstract
This manual describes how to create, access, and load the five types of disk files supported by the
Enscribe software.
Product Version
Enscribe 1.0
Supported Release Version Updates (RVUs)
This publication supports J06.03 and all subsequent J-series RVUs, H06.03 and all subsequent
H-series RVUs, and G06.27 and all subsequent G-series RVUs until otherwise indicated by its
replacement publications. To use increased Enscribe limits, the minimum RVUs are H06.28 and
J06.17 with specific SPRs. For a list of the required SPRs, see SPR Requirements for Increased
Enscribe Limits for the H06.28/J06.17 Release (page 18).
Document History
PublishedProduct VersionPart Number
June 2014Enscribe 1.0520369–009
July 2012Enscribe G09520369-007
February 2012Enscribe G09520369-006
February 2011Enscribe G09520369-005
February 2011Enscribe G09520369-004
February 2006Enscribe G09520369-003
December 2002Enscribe G09520369-002
New and Changed Information
Changes to the 520369-009 Version of the Manual
• Throughout document, change “classic key-sequenced” to “legacy key-sequenced (LKS)”.
• Throughout document, update increased partition size, block size, record length, key length,
and file size for format 2 legacy key-sequenced files (LKS2), format 2 enhanced key-sequenced
files (EKS), and standard format 2 Queue files.
• Update definition of primary and secondary extent sizes for EKS files in Unique Features of
EKS Files (page 70) and in the table in Comparing LKS Files, LKS2 Files, Standard Queue
Files, EKS Files, and EKS Files with Increased Limits (page 71).
• Add note about support for increased limits in Overview and Features (page 18) and Enscribe
Key-Sequenced Files (page 68).
• Add paragraph about increased file size limits in Key-Sequenced and Queue Files (page 48).
• Add table of SPRs required to achieve increased limits with H06.28 and J06.17 in SPR
Requirements for Increased Enscribe Limits for the H06.28/J06.17 Release (page 18).