Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) for EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
4-9
SCF Command Routing
1. Read about EnvoyACP/XF profile files and modifiers in Section 3, WAN Subsystem
Profiles and Modifiers for EnvoyACP/XF, of this manual.
2. Add a PROFILE object to the WAN subsystem.
a. Select the disk file name that corresponds to the communications protocol you
will use for the new line-handler process.
b. Use the SCF command ADD PROFILE to create a PROFILE object. (Skip this
step if you have already created a PROFILE object; (instead use the LIKE
parameter of the PROFILE attribute).
3. Add a DEVICE object to the WAN subsystem.
4. Start the DEVICE object.
Adding a PROFILE Object
The following example shows how to add a PROFILE object. The PROFILE name can
be any name that conforms to the naming guidelines in the WAN Subsystem
Configuration and Management Manual. In this example, the PROFILE name is
#MYANRM. PEXFANRM is the name of the template file, or disk file, that HP supplies
for the ADCCP-NRM communications protocol. $ZZWAN is the name of the WAN
subsystem and $SYSTEM.SWAN is a sample file location.
-> ADD PROFILE $ZZWAN.#MYANRM, FILE $SYSTEM.SYSnn.PEXFANRM
Starting a Process Through the WAN Subsystem
To start the process, issue the SCF START DEVICE command to the WAN subsystem
(see Figure 4-4). An example of the SCF START DEVICE command is:
-> START DEVICE $ZZWAN.#EXF01
Note. See the WAN Subsystem Configuration and Management Manual for more information
about the ADD DEVICE command.
Figure 4-3. Adding a Line-Handler Process
VST012.vsd
$ZZWAN
2. Create
object
DEVICE Object
($ZZWAN.#EX
F01)
Configuration
Data Base
WAN Manager
Subsystem
1. -> ADD DEVICE $ZZWAN.#EXF01, TYPE (11, 42),
IOPObject $SYSTEM.SYS01.BSPROCO,
PROFILE MYANRM,
CLIP 1,
LINE 0,
CPU 0,
ALTCPU 1,
ADAPTER CONC1,
RSIZE 536,
PATH A,
BDCASTON