Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-2
ABORT Command
Table 5-2 identifies which SCF commands provide EnvoyACP/XF subsystem
management in the WAN subsystem. For detailed information concerning syntax and
options for WAN subsystem commands, refer to the WAN Subsystem Configuration
and Management Manual.
ABORT Command
The ABORT command halts object operation as quickly as possible—only enough
processing is done to ensure that the subsystem can run again when it is restarted.
ABORT is a sensitive command that puts a LINE in the stopped state.
OUT file-spec
directs any SCF output generated for this command to the specified file. file-
spec must be a partially or fully qualified file name. If you do not specify this
option, the output goes to the home terminal.
object-name
is the name of the line to be aborted.
Example
The following command aborts the line called $ACPXF.
Table 5-2. SCF Commands and Object Types for the WAN Subsystem
Command DEVICE Object PROFILE Object
ADD DEVICE Command
on page 5-4 X
ADD PROFILE Command
on page 5-6 X
DELETE DEVICE Command
on page 5-18 X
INFO DEVICE Command
on page 5-19 X
INFO PROFILE Command
on page 5-25 X
NAMES DEVICE Command
on page 5-26 X
START DEVICE Command
on page 5-28 X
STOP DEVICE Command
on page 5-34 X
ABORT [ / OUT file-spec / ] LINE object-name
Example 5-1. ABORT LINE Command
-> ABORT LINE $ACPXF