Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-5
ADD DEVICE Command
RSIZE rsize
specifies the record length in bytes. RSIZE (RECSIZE) specifies the maximum
amount of information transferred between the EnvoyACP/XF line-handler process
and the DLC (running in the SWAN concentrator) in one operation. The attribute is
required for the WAN Manager program; however, the RSIZE value does not have
any actual function in configuring an EnvoyACP/XF line handler process.
The minimum value for RECSIZE (RSIZE) is 512 and the maximum is 4095 for all
protocols.
ADAPTER concname
is the SWAN concentrator to be used by this EnvoyACP/XF line-handler process.
The SWAN concentrator must have been previously defined with the WAN
subsystem SCF command ADD ADAPTER. For information about adding SWAN
concentrators, see the WAN Subsystem Configuration and Management Manual.
CLIP clipnum
is the communications line interface processor (CLIP) on the SWAN concentrator
specified by concname. Valid values are 1, 2, or 3.
LINE linenum
is the line number (0 or 1) on the selected CLIP specified by clipnum. linenum
must not have been previously selected for use by another line-handler process.
PATH { A | B }
is the Ethernet path (A or B) on the CLIP, specified by clipnum, that you prefer.
This path must have been previously defined with the WAN subsystem SCF ADD
PATH command. For information about defining Ethernet paths, refer to the WAN
Subsystem Configuration and Management Manual.
modifier_keyword
is the name of an optional modifier in profile_name.modifier_keyword is
added to the device record for this EnvoyACP/XF line-handler process.
Modifier names for the EnvoyACP/XF are listed in Section 3, WAN Subsystem
Profiles and Modifiers for EnvoyACP/XF.
modifier_value
is the value you want to assign to the optional modifier specified by
modifier_keyword. modifier_value assigns a value to
modifier_keyword in the device record for this EnvoyACP/XF line-handler
process.
Default values and ranges of values for EnvoyACP/XF modifiers are described in
Section 3, WAN Subsystem Profiles and Modifiers for EnvoyACP/XF.