Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-11
ALTER LINE Command
OUT file-spec
causes any SCF output generated for this command to go to the specified file.
file-spec must be a partially or fully qualified file name. If you do not specify this
option, the output goes to the home terminal.
object-name
is the name of the line to be altered.
ABMSETP
specifies whether EnvoyACP/XF automatically sets the P/F-bit in supervisory
frames.
ADDRESS1
specifies the address of the remote station. The range depends on the protocol
used.
ADDRESS2
specifies the address of the remote station. The range depends on the protocol
used.
ADDRESS3
specifies the address of the remote station. The range depends on the protocol
used.
Default ON
Range ON | OFF
Note Only for ABM
Default 1 for ABM
1 for NRM
Range 1 to 254 for ABM
1 to 254 for NRM
Default 3 for ABM
0 for NRM
Range 1 to 254 for ABM
1 to 254 for NRM
Default 0
Range 1 to 254 for ABM
1 to 254 for NRM