Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-12
ALTER LINE Command
ADDRESS4
specifies the address of the remote station. The range depends on the protocol
used.
ADDRSIZE
specifies the maximum number of octets found in the address field of each frame.
BROADCAST
Enables the #BDCAST virtual subdevice for a line. When #BDCST is enabled, the
supervisory station can transmit to all tributary stations configured for that line by
writing to #BDCAST rather than by listing all the stations.
CONTROLCARRIER
specifies that the controlled carrier for the modem is monitored.
DSRTIMER
specifies the time EnvoyACP/XF waits for DSR after the line is opened.
DUPLEX
specifies whether half-duplex or full-duplex modem operation is selected.
Default 0
Range 0 to 254
Default 1 for SDLC, HDLC, ABM
4 for NRM
Range 1 to 4
Default OFF
Range ON | OFF
Note Only for NRM multipoint configurations.
Default OFF
Range ON | OFF
Default 400
Range 0 to 32767
Units 10 milliseconds
Default HALF
Range HALF | FULL