Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-14
ALTER LINE Command
L1RETRY
specifies the maximum link-level, error recovery attempts.
L2HEARTBEAT
specifies that an RR frame is sent at every period specified in IDLETIMER time (if
the line is idle).
L2RETRY
specifies the maximum protocol-level, error-recovery attempts.
L2WINDOW
specifies the maximum I-frames that may be sent without receiving an
acknowledgment.
MODEMLOSSFATAL
specifies whether modem status is reported due to a modem error (loss of CTS,
DCD, and DSR).
PROGRAM
identifies the NonStop Kernel based 510 microcode file where the data link control
(DLC) task is located. This file is downloaded to the SWAN concentrator CLIP
RAM memory when the line is started.
Default 3
Range 0 to 255
Default OFF
Range ON | OFF
Default 3
Range 0 to 255
Default 7
Range 1 to 7 for standard control fields
1 to 127 for extended control fields
Default OFF
Range ON | OFF
Note Only for duplex, nonswitched lines
Default C8169P00
Range Not applicable
Note. This file must reside in the $SYSTEM.CSSnn subvolume.