Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-15
ALTER LINE Command
RCVRNRRETRY
specifies how the primary station handles an RNR (receiver not ready) condition
from a remote station. If this field is ON, then the primary station will reply to an
RNR received from the remote station with either DISC or FRMR depending on
whether the station is primary or secondary.
REJECT
specifies whether the line supports REJ frame transmission and reception.
RNRTIMER
is applied when an RNR is sent or received.
SNDRNRRETRY
specifies that RNR is sent out until the period defined in RNRTIMER expires (if the
station is in an RNR state).
SPEED
specifies the line speed.
SREJECT
specifies whether the line supports SREJ frame transmission and reception.
Default OFF
Range ON | OFF
Default OFF
Range ON | OFF
Default 0
Range 0 to 255
Units Seconds
Default OFF
Range ON | OFF
Default 96
Range 1 to 32767
Units 100 bits per second
Default OFF
Range ON | OFF