Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-17
ALTER LINE Command
T1TIMER
specifies the time between output completion and when a frame containing the P/F
bit receives a response (for a primary station). This timer is not used for a
secondary station.
V25
specifies that the EnvoyACP/XF line is used with a V.25 bis modem. It also implies
that this is a switched line.
XFERTIMER
clocks the period at the end of which retransmission of a frame may be initiated.
This timer is maintained for the communication link; the timer starts when a frame
transmission begins and clears when output completion occurs.
XLATE
specifies the selection of line EBCDIC-to-host ASCII translation for all or a portion
of the frame I-field.
XLATELENGTH
specifies the number of bytes in the I-field to be translated starting at the offset
specified in XLATEOFFSET.
XLATEOFFSET
specifies the offset for the beginning of translation in the I-field.
Default 500
Range 10 to 32767
Units 10 milliseconds
Default OFF
Range ON | OFF
Default 50
Range 10 to 32767
Units 10 milliseconds
Default OFF
Range ON | OFF
Default 0
Range 0 to FRAMESIZE
Default 0
Range 0 to FRAMESIZE