Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-27
START Command
specified in the ADD DEVICE command. You can use the asterisk (*) to specify all
configured DEVICE objects.
DEVICE
shows a list of the configured data communications subsystem objects.
Example
The format of the display for the NAMES DEVICE command is shown in
Example 5-15.
START Command
The START command is a sensitive command that places a line in the STARTED
state.
OUT file-spec
causes any SCF output generated for this command to go to the specified file.
file-spec must be a partially or fully qualified file name. If you do not specify this
option, the output goes to the home terminal.
object-name
is the name of the line to be started.
Example 5-15. NAMES DEVICE Command
27-> names device $zzwan.#*
WANMgr Names DEVICE $ZZWAN.#*
DEVICE
$ZZWAN.#EXF01
$ZZWAN.#ATPP1
$ZZWAN.#ATPP2
$ZZWAN.#IPCORE
$ZZWAN.#NCP
$ZZWAN.#XFSP0
$ZZWAN.#XFHP0
$ZZWAN.#XFHS0
$ZZWAN.#XFSS0
$ZZWAN.#CP6P1
START [ / OUT file-spec / ] LINE object-name