Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-28
START DEVICE Command
Example
This command line starts the LINE object named $ACPXF.
Considerations
•
A non-error completion of START indicates only that the subsystem initiated
processing for the START operation; it does not indicate whether the START
operation completed successfully.
•
A warning appears if the LINE object is already in the STARTED state.
•
The command is rejected if the LINE object is in the DIAGNOSING state.
•
The line handler process must have been previously added and started as a
DEVICE object in the WAN subsystem.
START DEVICE Command
To start a line-handler process, use the WAN subsystem SCF START DEVICE
command. This command creates the specified EnvoyACP/XF line-handler process
and allocates a logical device (LDEV) number.
The command syntax is as follows:
$ZZWAN.#device_name
is the device name of the EnvoyACP/XF line-handler process.
Example
The following command starts the device named $EXF01.
Example 5-16. START LINE Command
-> START LINE $ACPXF
START DEVICE $ZZWAN.#device_name
Example 5-17. START DEVICE Command
-> START DEVICE $ZZWAN.#EXF01