Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-33
STOP Command
LDEV
is the logical device number of the line.
Path
indicates the primary path to the CLIP.
PPID
is the processor number and PIN of the primary EnvoyACP/XF process.
Primary Trace
indicates whether the primary process is being traced.
State
is the current object state.
SWAN LINE
is the adapter name, CLIP number, and WAN line number on which the line is
configured.
STOP Command
The STOP command is a sensitive command that halts the operation of a line in an
orderly manner. Upon successful completion of the command, the line remains in
the STOPPED state until it receives a START LINE command.
OUT file-spec
causes any SCF output generated for this command to go to the specified file.
file-spec must be a partially or fully qualified file name. If you do not specify this
option, the output goes to the home terminal.
object-name
is the name of the line to be stopped.
Example
The following command stops the line $ACPXF.
STOP [ / OUT file-spec / ] LINE object-name
Example 5-23. STOP LINE Command
-> STOP LINE $ACPXF