Envoy ACP/XF Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
5-36
SWITCH Command
CPU cpu-number
selects the new the processor number. With conventional TCP/IP, CPU forces the
processor and path switch; cpu-number must be the processor of the backup
process. With PTCPIP, CPU forces the processor switch without changing the
path; cpu-number must be the processor of the backup process.
PATH A | B
selects the new path for the process. With conventional TCP/IP, PATH forces the
processor and path switch; A and B must not be the same as the path currently
used. With PTCPIP, PATH forces the path switch without changing the processor;
A and B must not be the same as the path currently used.
Examples
The following command changes the process $ACPXF to path A.
The following command changes the process $ACPXF to processor 2.
Considerations
•
When you execute this command, the final summary state remains unchanged.
•
When you specify a path or the processor in which the process is already running,
the command is rejected with a warning.
•
In a single command, you can specify only one of the attributes.
•
For cpu-number, use the backup processor number.
Example 5-26. SWITCH PROCESS Command (PATH)
-> SWITCH PROCESS $ACPXF, PATH A
Example 5-27. SWITCH PROCESS Command (CPU)
-> SWITCH PROCESS $ACPXF, CPU 2