Envoy ACP/XF Configuration and Management Manual

Converting EnvoyACP/XF Configuration Information
to SCF
EnvoyACP/XF Configuration and Management Manual—429232-003
A-2
CMI-to-SCF Conversion Guide
CMI-to-SCF Conversion Guide
For G-series releases, the command interface for EnvoyACP/XF is converted from the
Communications Management Interface (CMI) to SCF. This subsection explains how
D-series CMI commands correspond to G-series SCF commands.
CMI Command Conversion
Table A-2 matches each CMI command to the equivalent SCF command. The SCF
commands refer only to the SCF product module for EnvoyACP/XF. Additional
commands are available in the SCF product module for the WAN subsystem.
Can stop individual
terminals or printers
configured with the
MULTI attribute
N.A. No Yes No No No
Changes survive
system load
Yes Yes No Yes Yes No
Changes survive
processor reload
Yes Yes No N.A. Yes No
Changes survive
running SYSGENR
No No No No Yes No
1
For D-series releases, the system configuration database file is the $SYSTEM.SYSnn.OSCONFIG file.
For G-series releases, the system configuration database file is the $SYSTEM.ZSYSCONF.CONFIG file.
2
Except for system attributes preconfigured by SYSGENR.
Table A-2. Comparison of CMI and SCF Commands (page1of2)
CMI Command SCF Command
ABORT ABORT
ACTIVATE None
ALTER ALTER
ALTER PROCESS, CPU PRIMARY *
ALTER PROCESS, PATH SWITCH *
INFO INFO
START START
* This SCF command can be used to achieve a similar, but not identical, function as the CMI command.
Table A-1. Configuration Programs for D-Series and G-Series RVUs (page 2 of 2)
D-Series RVUs G-Series RVUs
Capability SYSGENR COUP CMI SYSGENR
SCF to
WAN
Sub-
system
SCF to
EnvoyACP/XF