Envoy ACP/XF Configuration and Management Manual

Configuration Quick Start
EnvoyACP/XF Configuration and Management Manual—429232-003
1-5
Task 2: Create the Line-Handler Process
PATH { A | B }
is the Ethernet path (A or B) on the CLIP, specified by clipnum, that you prefer.
This path must have been previously defined through the WAN subsystem SCF
ADD PATH command. For information about defining Ethernet paths, refer to the
WAN Subsystem Configuration and Management Manual.
modifier_keyword
is the name of an optional modifier in profile_name.modifier_keyword is
added to the device record for this EnvoyACP/XF line-handler process.
Modifier names for the EnvoyACP/XF are listed in Section 3, WAN Subsystem
Profiles and Modifiers for EnvoyACP/XF.
modifier_value
is the value you want to assign to the optional modifier specified by
modifier_keyword. modifier_value assigns a value to
modifier_keyword in the device record for this EnvoyACP/XF line-handler
process.
Default values and ranges of values for EnvoyACP/XF modifiers are described in
Section 3, WAN Subsystem Profiles and Modifiers for EnvoyACP/XF.
Considerations
•
Not all modifiers have associated values.
•
The modifier_keyword and modifier_value parameters do not add the
specified modifier, or a modifier and its associated value, to the profile used by the
device. Use the ADD PROFILE command to add a modifier, or a modifier and its
associated value, to a profile.
Example 1-2 issues the SCF ADD DEVICE command to the WAN subsystem to add a
line-handler process using the PROFILE object from the previous example.
Example 1-2 shows the optional modifier BDCASTON (the default for NRM):
Example 1-2. Adding a Line-Handler Process
-> ADD DEVICE $ZZWAN.#EXF01,
TYPE (11, 42),
IOPOBJECT $SYSTEM.SYS01.BSPROCO,
PROFILE MYANRM,
CLIP 1,
LINE 0,
CPU 0,
ALTCPU 1,
ADAPTER CONC1,
RSIZE 536,
PATH A,
BDCASTON