Envoy ACP/XF Configuration and Management Manual

WAN Subsystem Profiles and Modifiers for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
3-2
Optional Modifiers
SUBTYPE n
Specifies the type of XF line based on the protocol used:
Optional Modifiers
To customize your configuration, you can specify some of the following modifiers. Most
of these modifiers have default values that come with the profile files in your system.
Some of the defaults differ, depending on which profile file you have specified. (These
defaults are noted in the modifier descriptions later in this section.)
Functional Categories
If you are configuring an EnvoyACP/XF line, refer to Table 3-1. Use this table to identify
the names of modifiers that you might wish to use, then refer to the modifier
descriptions—given in alphabetical order later in this section—for additional
information.
Default: Depends on protocol (see below)
Units: N/A
Range: N/A
Subtype Protocol Profile Name
40 SDLC PEXFSDLC
41 HDLC PEXFHDLC
42 ADCCP PEXFAABM, PEXFANRM
Table 3-1. Modifiers by Functional Category (page 1 of 2)
Functional
Category Modifier Names
Station
Configuration/
Transmission
Control
ADDRESS, FRAMESIZE, L2WINDOW, MAXPUS,
SECONDARY/PRIMARY
Line and
Modem Control
CONTCF/NOCONTCF, DSRTIMER, FLAGFILL, FULL/HALF,
MODEMLOSSFATAL, MODEMTIMER, SPEED, SWINCARRIER,
SWITCHED/NOSWITCH, SWOUTCARRIER, TWS/TWA, V25
Error Handling
L1RETRY, L2RETRY, RECVRNRRETRY/NORECVRNRRETRY,
SENDRNRRETRY/NOSENDRNRRETRY, REJ, RNRTIMER, SREJ,
T1TIMER, THRESHOLD, XFERTIMER
Concentrator PROGRAM, RS232/RS422
Character Code ASCII, EBCDIC, TRANSLATE/NOTRANSLATE, TRNSLENGTH,
TRNSOFFSET