Envoy ACP/XF Configuration and Management Manual

WAN Subsystem Profiles and Modifiers for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
3-25
Optional Modifier Descriptions
MODEMLOSSFATAL/NOMODEMLOSSFATAL
Specifies that a modem error (loss of CTSDCD) causes EnvoyACP/XF to immediately
report the modem status and put the link in the disconnect state.
This modifier applies only to lines specified as FULL and NOSWITCH (leased). If you
do not specify MODEMLOSSFATAL, statistics of these errors are kept, and level-1
protocol operation continues.
You can alter this modifier by issuing an SCF ALTER LINE command to the
EnvoyACP/XF subsystem but not by issuing a SETMODE procedure call in an
application.
MODEMTIMER
Specifies the time in 100ths of seconds that level 2 waits for DSR to be reasserted
before reporting DSR loss.
NOABMSETP
See ABMSETP/NOABMSETP on page 3-8.
NOAUTOTESTRESP
See AUTOTESTRESP/NOAUTOTESTRESP on page 3-11.
NOCONTCF
See CONTCF/NOCONTCF on page 3-14.
NOEXTENDEDCONTROL
See EXTENDEDCONTROL/NOEXTENDEDCONTROL on page 3-15.
NOFLAGFILL
See FLAGFILL/NOFLAGFILL on page 3-16.
Default: NOMODEMLOSSFATAL (Modem error statistics are kept, but modem
loss is not fatal to the link.)
Units: N/A
Range: N/A
Note: Only for full-duplex, nonswitched lines.
Default: 0
Units: .01 second (100ths of seconds)
Range: 0 to 32,767