Envoy ACP/XF Configuration and Management Manual

WAN Subsystem Profiles and Modifiers for
EnvoyACP/XF
EnvoyACP/XF Configuration and Management Manual—429232-003
3-31
Optional Modifier Descriptions
OPTION6
This is applicable only in NRM mode. When set, in LDS state, the primary station will
not set poll bit unless application sets the poll bit.
PRIMARY/SECONDARY
Specifies that the station connected to the line is a primary or combined station.
You can set or override this modifier by issuing a SETMODE 16 call in an application
or by issuing an SCF ALTER LINE command to the EnvoyACP/XF subsystem (note
that the PRIMARY/SECONDARY modifier is called STATION in the EnvoyACP/XF
subsystem SCF product module).
PROFILE^IDn
This modifier is applicable to all EnvoyACP/XF line types. It is for internal use only and
should not be modified.
PROGRAM filename
Specifies the disk file containing the CLIP download module for the ServerNet wide-
area network concentrator. The PROGRAM filename is used in error-recovery
situations and when no disk file name is provided with the SCF START command.
You can set or override this modifier by issuing an SCF ALTER LINE command to the
EnvoyACP/XF subsystem but not by issuing a SETMODE procedure call from an
application.
Note. Once this modifier is added to the device record, it can only be removed by using the
SCF ALTER DEVICE command with the RESET modifier option.
Default: PRIMARY
Units: N/A
Range: N/A
See
also:
SECONDARY
Default: filename = $SYSTEM.CSSnn.C8169P00 (WANADCCP CLIP code)
Units: N/A
Range: N/A