Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
Contents
Envoy Application Programming Manual—427159-001
xi
C. File-System Procedures (continued)
C. File-System Procedures (continued)
HALTPOLL C-21
OPEN
C-22
READ[X]
C-24
SETMODE
C-26
SETMODENOWAIT
C-31
WRITE[X]
C-32
WRITEREAD[X]
C-34
D. Statistics Messages
E. S-Series Changes to Envoy
NonStop™ Himalaya S-Series Server Architecture E-1
G-Series Migration Considerations
E-1
CBSENSEON and CFSENSEON Modifiers
E-1
LEOTRESYN and NOLEOTRESYN Modifiers
E-2
Treatment of Characters After the Termination Character
E-2
Number of SYN Characters
E-2
DTR Drop
E-2
Reporting of Parity Error
E-3
Half-Duplex Support for Asynchronous Lines
E-3
Controller Replacement
E-3
SYSGEN and COUP
E-3
Unit Numbers
E-4
FDX Line Changes
E-4
No Support for Auto-Call Unit
E-4
Glossary
Index
Examples
Example 2-1. Transmission 2-7
Example 2-2.
Basic READ-WRITE Operation 2-7
Example 2-3.
Monitor the Line for Incoming Messages 2-13
Example 2-4.
WRITE-READ Interactions 2-14