Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
Contents
Envoy Application Programming Manual—427159-001
xii
Examples (continued)
Examples (continued)
Example 2-5. Address List for Supervisor Station A 2-16
Example 2-6.
Address List for Tributary Stations B and C 2-17
Example 2-7.
Polling Example 2-19
Example 2-8.
Selection Example 2-21
Example 2-9.
Error Handling By Receiver 2-24
Example 3-1.
Initial Read (Line in CONTROL State) 3-18
Example 3-2.
Timeout on Initial Read 3-18
Example 3-3.
Continuation READ (Line in READ State) 3-20
Example 3-4.
Initial READ (Line in WRITE State) 3-21
Example 3-5.
Initial READ of ID (Line in CONTROL State) 3-22
Example 3-6.
Initial WRITE (Line in CONTROL State) 3-23
Example 3-7.
Continuation WRITE (Line in WRITE State) 3-24
Example 3-8.
Initial WRITEREAD (Line in CONTROL State) 3-26
Example 3-9.
Continuation WRITEREAD (Line in WRITE State) 3-27
Example 3-10.
WRITEREAD Procedure (ID Exchange by Caller) 3-28
Example 3-11.
WRITEREAD Procedure (ID Exchange by Called Station) 3-29
Example 3-12.
WRITEREAD Procedure (Multileaving Conversational
Exchange) 3-29
Example 3-13.
CONTROL Procedure (Send EOT) 3-31
Example 3-14.
CONTROL Procedure (Send WACK) 3-31
Example 3-15.
CONTROL Procedure (Enable RVI) 3-31
Example 3-16.
CONTROL Procedure (Send TTD) 3-32
Example 3-17.
Send Messages from the Local Station 3-44
Example 3-18.
Program Code for read^text and write^text 3-45
Example 3-19.
Read Messages from the Remote Station 3-51
Example 3-20.
Send Messages with WRITEREAD Calls 3-52
Example 3-21.
RVI Sequences 3-54
Example 3-22.
ID Exchange Sequence 3-55
Example 4-1.
Address List Format 4-11
Example 4-2.
Build an Address List 4-12
Example 4-3.
Continuous Polling 4-15