Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
Contents
Envoy Application Programming Manual—427159-001
xiv
Examples (continued)
Examples (continued)
Example 5-14. Selected Tributary Receives a Message 5-39
Example 5-15.
Program Code for BISYNC Multipoint Tributary 5-40
Example 6-1.
Configuration of a NASDAQ Full-Duplex Line 6-4
Example 6-2.
WAN Manager STATUS SERVER Command 6-5
Example 7-1.
Address List 7-9
Example 7-2.
Build an Address List 7-10
Example 7-3.
Specify Continuous Polling 7-12
Example 7-4.
Change a Line’s Polling Type 7-13
Example 7-5.
Specific Polling 7-14
Example 7-6.
Disable Polling for a Specific Terminal 7-17
Example 7-7.
Remove Terminals From Nonresponding List 7-18
Example 7-8.
Message Control Word 7-19
Example 7-9.
Initial READ (Line in CONTROL State) 7-26
Example 7-10.
Continuation READ (Line in READ State) 7-27
Example 7-11.
WRITE of Normal Text Message (Line in CONTROL State) 7-29
Example 7-12.
WRITE of Special Message (Line in CONTROL State) 7-29
Example 7-13.
WRITE of Normal Text Message (Line in READ State) 7-30
Example 7-14.
WRITE of Special Message (Line in READ State) 7-30
Example 7-15.
WRITEREAD Procedure (Line in CONTROL State) 7-32
Example 7-16.
WRITEREAD Procedure (Line in READ State) 7-32
Example 7-17.
CONTROL Procedure (Send EOT) 7-33
Example 7-18.
Declarations Used in the Programming Examples 7-39
Example 7-19.
Poll the Line and Read a Message from the Terminal 7-41
Example 7-20.
Select and Send Operation 7-42
Example 7-21.
Send a Broadcast-Select Message 7-43
Example 7-22.
Program Code for a Broadcast-Select Message 7-44
Example 7-23.
Send a Fast-Select Message 7-45
Example 7-24.
Program Code for a Fast-Select Message 7-46
Example 7-25.
Send Function and Read Message 7-47
Example 7-26.
Program Code for Send Function and Read Message 7-48
Example 8-1.
Address List 8-8
Example 8-2.
Build an Address List 8-9