Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
Envoy Application Programming Manual—427159-001
xxiii
What’s New in This Manual
Manual Information
Envoy Application Programming Manual
Abstract
The Envoy subsystem provides general-purpose protocol support that enables
application programs or terminals to communicate over communications lines on a
ServerNet wide area network (SWAN) concentrator. This manual describes Envoy
application programming, management functions, and the implementation of protocols
used with Envoy.
Product Version
Envoy G-Series
Supported Releases
This manual supports G03.00 and all subsequent G-series releases until otherwise
indicated in a new edition.
Document History
New and Changed Information
This is a new manual. For G-series releases, this manual and the Envoy Configuration
and Management Manual replace all the other Envoy manuals.
Part Number Published
427159-001 November 2000
Part Number Product Version Published
427159-001 NA November 2000