Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
ADM-2 Multipoint Supervisor Protocol
Envoy Application Programming Manual—427159-001
7-36
WRITE Operation
Table 7-12 lists the error codes that can occur during a continuation READ operation.
WRITE Operation
Figure 7-8 shows the action of the supervisor station in response to line conditions on a
WRITE.
Table 7-12. Continuation READ Error Codes
Error Code Description
162 Operation timed out
172 Reply not proper for protocol
173 Transmission error
177 Text overrun