Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
TINET Multipoint Supervisor Protocol
Envoy Application Programming Manual—427159-001
8-3
TINET Multipoint Supervisor Polling
TINET Multipoint Supervisor Polling
The supervisor polls the terminals and accepts messages by calling the READ
procedure. Figure 8-1 shows the TINET multipoint supervisor polling sequence.
Figure 8-1. TINET Multipoint Supervisor Polling
042CDT .CDD
No
2
Yes
Did a Polled
Station
Respond with
Text?
READ Completes
The Request from
the Terminal is
Processed
CALL DEFINELIST...
CALL OPEN... nowait
CALL READ...
The Network is
Polled
1