Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
Asynchronous Line Supervisor Protocol
Envoy Application Programming Manual—427159-001
10-10
File-System Procedures
3 = 134.5
4 = 150
5 = 300
6 = 600
7 = 1200
8 = 180
9 = 200
10 = 2400
11 = 3600
12 = 4800
13 = 7200
14 = 9600
15 = 19200
23 Modifies character size
1 0: 5 bits per character
1: 6 bits per character
2: 7 bits per character
3: 8 bits per character
24 1 Modifies character parity
0 = odd parity
1 = even parity
2 = no parity
135 1 Enable/disable parity checking
.<15> 0: Enables parity checking
1: Disables parity checking
147 1 Enables/disables DSR detection
.<15> 0: Enables DSR detection
1: Disables DSR detection
Note. For a complete list of SETMODE procedures supported by the Envoy protocols, see the
SETMODE procedure description in Ta ble C-5 on page C-27, which also lists the analogous
modifier for these procedures.
Table 10-5. SETMODE Operations for Asynchronous Line
Supervisor (page 2 of 2)
Operation Parameter Description