Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
File-System Procedures
Envoy Application Programming Manual—427159-001
C-28
SETMODE
1: Poll next station after EOT is received
(BISYNC multipoint only)
POLLONEOT
.<3> 0: Enables incoming parity checking for
ASYNC or SIMPLEX
CHECK
1: Disables incoming parity checking for
ASYNC or SIMPLEX
NOCHECK
.<3> 0: Normal BISYNC CRC calculation
1: SWIFT BISYNC CRC calculation SWIFT
.<3> 0: For the Full-Duplex protocol only,
disables application’s ability to receive
control characters
1: For the Full-Duplex protocol only,
enables application’s ability to receive
control characters
.<10> 0: Disables BISYNC conversational
multileaving mode
1: Enables BISYNC conversational
multileaving mode
MULTILEAVING
.<11> 0: Disables ID exchange
1: Enables ID exchange IDEXCHG
.<12> 0: Specifies half-duplex line HALF
1: Specifies full-duplex line FULL
.<13> 0: Secondary point-to-point SECONDARY
1: Primary point-to-point** PRIMARY
.<14:15> 0: Point-to-point, nonswitched PPNSW
1: Point-to-point, switched PPSW
2: Multipoint tributary MPTRIB
3: Multipoint supervisor* MPSUPV
16 2 Polling interval in 10-millisecond units POLLINT
17 1 Sets intermediate block size in words ITBSIZE
18 1 Set statistics threshold THRESHOLD
Table C-5. SETMODE Operation Codes (page 2 of 4)
Operation Parameter Description
Analogous
Modifier