Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
S-Series Changes to Envoy
Envoy Application Programming Manual—427159-001
E-4
Unit Numbers
Unit Numbers
While adding the device, unit number is not required, except for lines of subtype 30, 31,
32 and 33.
FDX Line Changes
Starting from this release, FDX lines (Write and Read) need to be MULTIed on a single
line of any CLIP so as to get the same effect as that of COUPing these lines on units n
and n+1 of a 3602 controller (where n = 0, 2, 4, 6)
No Support for Auto-Call Unit
ACU is not supported in G-series releases.