Envoy Application Programming Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Application Programming With Envoy
- 7 ADM-2 Multipoint Supervisor Protocol
- 8 TINET Multipoint Supervisor Protocol
- 9 Burroughs Point-To-Point Protocol
- 10 Asynchronous Line Supervisor Protocol
- A ASCII Character Set
- B ASCII to EBCDIC Code Conversion
- C File-System Procedures
- D Statistics Messages
- E S-Series Changes to Envoy
- NonStop™ Himalaya S-Series Server Architecture
- G-Series Migration Considerations
- CBSENSEON and CFSENSEON Modifiers
- LEOTRESYN and NOLEOTRESYN Modifiers
- Treatment of Characters After the Termination Character
- Number of SYN Characters
- DTR Drop
- Reporting of Parity Error
- Half-Duplex Support for Asynchronous Lines
- Controller Replacement
- SYSGEN and COUP
- Unit Numbers
- FDX Line Changes
- No Support for Auto-Call Unit
- Glossary
- Index
Envoy Application Programming Manual—427159-001
Index-1
Index
Numbers
10Base-T Ethernet connections 2-2
3602 byte-synchronous controller 2-2, E-1
3602 controller emulator 2-2
3603 asynchronous controller 2-2, E-1
3603 controller emulator 2-2
A
ACK 3-1
Address list 2-16/2-18
ADM-2
multipoint supervisor protocol 7-1
/7-46
protocol 1-8, 2-3
Architecture, Envoy subsystem 1-3
ASCII character set 2-1, 3-2, 3-5, 4-1, 4-5,
A-1
ASCII-to-EBCDIC translation 3-5, 4-5, B-1
Asynchronous
concentrator type 1-8
devices 2-1
environment 2-1
line supervisor protocol 10-1/10-27
protocol 1-8, 2-1, 2-3
AWAITIO procedure 2-4, C-1, C-4
B
BCC
computation of 3-3
, 3-15
errors 2-22, 4-5
Binary Synchronous Communication point-
to-point standard 3-1
Binary synchronous (BISYNC)
See BISYNC
BISYNC
centralized multipoint supervisor
protocol 4-1
/4-55
BISYNC (continued)
multipoint tributary protocol 2-8
,
5-1
/5-46
point-to-point links 2-8
point-to-point network 3-4
point-to-point protocol 3-1/3-56
protocol 1-8, 2-3, 2-6/2-9, 2-22
text 2-9
transmission 2-6
Bit-synchronous devices 2-1
Block-check characters (BCCs)
See BCC
Broadcast select 7-22
Burroughs
multipoint configurations 1-8
point-to-point protocol 9-1/9-16
protocol 1-8, 2-3
Byte-synchronous
concentrator type 1-8
devices 2-1
environment 2-1
protocol 2-1
C
CANCEL procedure 2-4, C-2, C-7
CANCELREQ procedure 2-4
CBT 3-3
Centralized multipoint
data links 2-11
network 1-1, 1-7
CHANGELIST procedure 2-4, 2-17/2-18,
C-2, C-7
Check-character
generation 3-2
, 4-1
verification 3-2, 4-1
Circuit Assurance Mode (ID exchange) for
switched lines 3-2