Envoy Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
Envoy
Envoy Configuration and Management Manual—429861-001
5-15
ALTER LINE BSCBURPTP Command
ALTER LINE BSCBURPTP Command
The attribute-spec for the ALTER LINE BSCBURPTP command (Byte-synchronous
Burroughs point-to-point lines) is one of the following attribute name and value
combinations. The attributes are listed alphabetically in Section 3, WAN Subsystem
Profiles and Modifiers for Envoy.
Example
The following command alters the line $EVY1, including the BLOCKCHK value and
the SYNCS attribute:
-> ALTER LINE $EVY1, BSCBURPTP, BLOCKCHK CRC16, SYNCS 3
[ STATIONTYPE { PRIMARY | SECONDARY } ]
[ CONNTYPE { PPSW | PPNSW } ]
[ SYNCS { 2 through 15 } ]
[ CHARSET { ASCII | EBCDIC | KATAKANA } ]
[ CHARSIZE { 5 | 6 | 7 | 8 } ]
[ BLOCKCHK { CRC16 | CCITT | LRC8 } ]
[ BUFFER { DEDICATED | POOLED } ]
[ BUFSIZE { 0 through 32767 } ]
[ BISYNCINTF { RS232 | RS422 } ]
[ DTR { OFF | ON } ]
[ CLEARRTS { OFF | ON } ]
[ RAISERTS { OFF | ON } ]
[ MONITORCTS { OFF | ON } ]
[ MONITORCD { OFF | ON } ]
[ THRESHOLD { 0 through 255 } ]
[ TIMEOUT { 0 through 32767 } ]
[ RETRIES { 0 through 255 } ]
[ SPEED { 6 | 12 | 18 | 24 | 36 | 48 | 72 | 96 | 192 | 384 }
{ 480 | 560 }