Envoy Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
Envoy
Envoy Configuration and Management Manual—429861-001
5-16
ALTER LINE BSCMPSUPV Command
ALTER LINE BSCMPSUPV Command
The attribute-spec for the ALTER LINE BSCMPSUPV command (byte-synchronous
multipoint supervisor or Burroughs multipoint supervisor lines) is one of the following
attribute name and value combinations. The attributes are listed alphabetically in
Section 3, WAN Subsystem Profiles and Modifiers for Envoy
.
Example
The following command alters the line $EVY1, including the POLLSELSEQ value and
the POLLINT attribute:
-> ALTER LINE $EVY1, BSCMPSUPV, POLLSELSEQ EOT, POLLINT 300
[ SYNCS { 2 through 15 } ]
[ CHARSET { ASCII | EBCDIC | KATAKANA } ]
[ CHARSIZE { 5 | 6 | 7 | 8 } ]
[ BLOCKCHK { CCITT | CRC16 | LRC8 } ]
[ BUFFER { DEDICATED | POOLED } ]
[ BUFSIZE { 0 through 32767 } ]
[ ITBSIZE { 0 through 32767 } ]
[ ACKSEQ { ASCII | BISYNC } ]
[ POLLSELSEQ { EOT | NOEOT } ]
[ POLLONEOT { OFF | ON } ]
[ POLLINT { 0 through 32567 } ]
[ BISYNCINTF { RS232 | RS422 } ]
[ DTR { OFF | ON } ]
[ CLEARRTS { OFF | ON } ]
[ RAISERTS { OFF | ON } ]
[ MONITORCTS { OFF | ON } ]
[ MONITORCD { OFF | ON } ]
[ MPWACKSEL { OFF | ON } ]
[ MPWACKTEXT { OFF | ON } ]
[ NOERRDIFF { OFF | ON } ]
[ THRESHOLD { 0 through 255 } ]
[ TIMEOUT { 0 through 32767 } ]
[ RETRIES { 0 through 255 } ]
[ SPEED { 6 | 12 | 18 | 24 | 36 | 48 | 72 | 96 | 192 | 384 }
{ 480 | 560 }