Envoy Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
Envoy
Envoy Configuration and Management Manual—429861-001
5-27
INFO LINE Command
BSCMPTRIB
FDX
See ALTER LINE Command
on page 5-10 for more information on the ALTER
attribute sets.
Following are definitions for the display fields not defined under the previous example.
For more information on these items, refer to Section 3, WAN Subsystem Profiles and
Modifiers for Envoy.
Number of Units
indicates the number of units per logical line.
Program
indicates the DLC download program filename.
Example 5-4. INFO LINE DETAIL Command for ASC Alter Attribute Set
11-> info line $asca,detail
Envoy Detail INFO LINE \IDC12.$ASCA
Type/SubType..... (7 ,40) Recsize.......... 512
DLC Type......... ASYNC Number of Units.. 1
Program.......... $SYSTEM.CSS02.C0017P00
Driver........... SIMPLEX Protocol......... ASYNC
Interrupt Handler NO^SPECIAL
*Buffering Mode... DEDICATED *Buf Size in Words 1024
Async Info
*Conn Type........ PTP^SW Alter Attr Set... ASC
*Read Only........ OFF
*Baud............. 2400 *CharSize......... 8
*Parity........... NONE *Stop Bit......... OFF
*Echo............. OFF *No Parity Check.. OFF
*Break Enable..... OFF *TPause........... OFF
*Tchar1........... %200 *Tchar2........... %377
*Tchar3........... %200 *Tchar4........... %377
*Etx Char......... %3 *Cntl Term........ NONE
Duplex........... FULL^DUX *Async Intf....... EIA
*Dual212.......... OFF *Dsr Sense........ ON
WaitDsrDrop...... OFF
Retries.......... 0 *Timeout..........00:10.00
*Threshold........ 100