Envoy Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
Envoy
Envoy Configuration and Management Manual—429861-001
5-28
INFO LINE Command
Driver
indicates the name of the driver module.
Protocol
indicates the name of the communications protocol.
Interrupt Handler
indicates the interrupt handler being used. The term NO^SPECIAL listed next to
Interrupt Handler indicates that the system’s interrupt handler is being used, rather
than an Envoy interrupt handler.
Buffering Mode
indicates whether the mode of buffering is DEDICATED or POOLED.
Buf Size in Words
indicates the buffer size in words.
Conn Type
indicates whether the connection type is active or passive.
Alter Attr Set
indicates the ALTER attribute set used. See ALTER LINE Command on page 5-10
for more information about alter attribute sets.
Read Only
indicates if the line is read only.
Baud
indicates the speed of the line in baud rates.
CharSize
indicates the character size in bits per character.
Parity
indicates if the parity is ODD, EVEN, or NONE.
Stop Bit
indicates whether the stop bit is ON or OFF.
Echo
indicates if echo is ON or OFF.